

Bosch
Stove Repair
A German appliance maker, part of BSH, whose stoves are usually the slide-in kind that sits level with the counter.
Mon–Sat, 8am–8pm
- 3 stove types
- 6 problems we see
- 15 error codes
Book a visit
Three short steps, about a minute.
or call (844) 415-7620
Loading appointment form…
The appointment form couldn’t load. Please try again.
Bosch stoves,
specifically.
Bosch sells slide-in stoves in gas, electric, dual fuel and induction versions, plus freestanding gas and dual fuel models. Its owner pages keep separate code lists for slide-in and freestanding stoves, and the same code can mean different things on each.
The Bosch lineupBuilds3 stove types
Gas stove · Electric stove · Induction stove
Called out forStove Flame Too High or Too Low
and 5 more problems on Bosch
Repairs we do10 repairs, on any make
Diagnostic visit · Stove burner repair · Igniter and spark switch repair · Coil burner and socket repair
Error codese005 · e011 · E100 · e101 · e126
15 Bosch codes with a page of their own
The Bosch
lineup.
Bosch builds 3 of the 4 stove types this site covers. Which one decides how the visit is planned.
All stove typesWhat is particular
to Bosch.
This page draws on Bosch's slide-in and freestanding code pages and on the use and care manual for its dual fuel and gas slide-in stoves (HDI8056U, HGI8056UC and related models). The rating label tells which code list applies.
Only the burners in a blackout
Bosch's slide-in manual says that during a power failure only the stovetop burners can be lit by hand. The oven and the electronic features wait for power.
Judge the flame after five minutes
Bosch asks you to let the burners run 4 to 5 minutes before judging the flame, since some yellow streaking is normal at first. A flame that stays mostly yellow points at the regulator setting for your gas type.
Caps belong to their burner
Bosch says the burner caps must not be swapped between burners, and the igniters should be cleaned regularly with a small non-metallic brush. Mixed-up caps after cleaning are a common reason for an uneven flame.
Cord colors after a move
On freestanding models, Bosch's first check for the e101 sensor code is that the power cord's wire colors match the wires on the stove. A stove that shows e101 right after a move or install should have its connection checked before anything else.
Parts
Bosch's freestanding and slide-in stoves use different code sets and different controls, so the model number decides the part. Parts availability was not confirmed on a Bosch source.
Repair or replace
Mixed-up burner caps, a panel lock, demo mode and a hot pan near the controls need no part. For a sensor, lock or board on a slide-in fitted to the cabinetry, repair is usually easier than replacing it.
Book your Bosch visitWhat we are
called out for.
On Bosch, most often stove flame too high or too low.
All problemsNot a
Bosch?
Bosch is one of 32 stove makes on this site. The other 31 each have a page of their own.
All 32 brandsBosch stove repair,
where we come out.
9 metros, each with its own page.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions about
Bosch stoves.
Can I use my Bosch gas stove when the power is out?
The flames on my new Bosch look yellow. Is that a problem?
How do I lock the controls on my Bosch?
Does it matter which cap goes on which burner on my Bosch?
Back to your everyday
Book your Bosch visit.
Have the stove's model number ready — on Bosch it decides which parts come on the first visit.