Bosch freestanding stove shows e011
Bosch lists e011 as a touch sensor failure on the oven control panel.
Mon–Sat, 8am–8pm
- Knobs, keys and display
- Knob and switch replacement
- Source: Bosch
Book a visit
Three short steps, about a minute.
or call (844) 415-7620
Loading appointment form…
The appointment form couldn’t load. Please try again.
What e011
actually means.
Bosch lists e011 as a touch sensor failure on the oven control panel. Dirt, moisture or a failed sensor keeps the panel from reading your touches correctly.
Bosch stove display
What to do when e011 shows on the stoveKind of codeKnobs, keys and display
A key on the panel was held down too long, reported a press nobody made, or stopped answering; or a knob's switch told the stove it was on when it was off. Water, a spill or grease worked in behind a knob is ruled out first, then the switch, the key panel and the cable to the board. If a burner keeps heating while the keys or knobs do nothing, switch the stove off at the breaker.
Usually leads toKnob and switch replacement
Stove knobs that are cracked, loose or spin in place, and the switches behind them that leave a burner stuck on high or dead, replaced at the knob, the stem or the switch.
Shows up asStove Display Blank or Flashing
The clock and display on the stove have gone dark, or they flash the time, a word or a string of characters and ignore the keys you press.
MakeBosch
A German appliance maker, part of BSH, whose stoves are usually the slide-in kind that sits level with the counter.
SourceBosch: freestanding range error codes
Where e011 is documented: Bosch's freestanding range code page, listed for both its electric and gas freestanding models.
Before you book,
in this order.
Each step comes from Bosch's own guidance for e011 on its stoves. Follow it to the end: the last card says whether this is a visit.
Clean the control panel and wipe it completely dry.
Switch the breaker off and wait five minutes, then turn it back on.
Book a visit if e011 returns on a clean, dry panel.
Still there?
It usually turns into knob and switch replacement. Book with the code and the model number.
What not to do
e011 is not an oven heating code. The oven may heat fine once the panel reads touches again.
What you may
notice with it.
The stove problems e011 tends to arrive with. Answer these at the stove before anyone is booked.
All problems
Where e011 usually leads
Knob and switch replacement.
Bosch
stoves.
A German appliance maker, part of BSH, whose stoves are usually the slide-in kind that sits level with the counter.
Bosch stove repairMore Bosch codes
All 15 Bosch codesKnobs, keys and display on other makes
All 29 codes of this kind
Gas stove
A stove with gas burners on top, whether its oven below runs on gas too or on electricity, fed by one gas line behind it and plugged into a wall outlet for the spark.
Electric stove
A stove that runs entirely on electricity through a heavy cord and a large outlet behind it, with coil burners that lift out or a smooth glass stovetop with elements under it.
Induction stove
A stove with a flat glass top that heats the pan itself through a magnetic field, run by touch keys and power boards, with an electric oven underneath.
In Bosch's own words
Touch sensor failure on oven control panel.
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Where e011 is documented: Bosch's freestanding range code page, listed for both its electric and gas freestanding models.
Bosch e011 stove repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about e011.
Can I clear e011 myself?
Can a greasy control panel bring up e011 on a Bosch?
My Bosch panel ignores one key and shows e011. What now?
Is e011 on a Bosch the same as a locked panel?
Back to your everyday
Still showing e011?
Book with the code written exactly as the stove shows it, the full model number, and whether you notice any smell of gas or hot wiring — when there is a code, that is where the diagnosis starts.