AGA Elise or Mercury induction stove
showing E2
On the Elise and Mercury induction models, E2 means the electronic unit beneath the glass has overheated.
Mon–Sat, 8am–8pm
- Stovetop elements
- Glass stovetop repair
- Source: AGA
Book a visit
Three short steps, about a minute.
or call (844) 415-7620
Loading appointment form…
The appointment form couldn’t load. Please try again.
What E2
actually means.
On the Elise and Mercury induction models, E2 means the electronic unit beneath the glass has overheated. AGA points first to the installation and whether the stove gets enough ventilation, and adds that a pan allowed to boil dry can also bring it on.
AGA stove display
What to do when E2 shows on the stoveKind of codeStovetop elements
A burner on an electric or induction stovetop did not heat the way the knob or key asked, heated with nothing set, or ran hotter than the setting. The pan, a lock left on and the switch behind the knob are checked before the element under the glass, its limiter or an induction board is changed. If a burner keeps heating after it has been switched off, turn the stove's breaker off before anything else.
Usually leads toGlass stovetop repair
Smooth glass stovetops on electric and induction stoves with a cold circle, a cracked or chipped top, or a hot-surface light that stays on, repaired under the glass or with a new top.
Shows up asStove Error Code
The stove shows letters and numbers, a flashing symbol or a short message, beeps, and the oven or a burner stops or will not start.
MakeAGA
A British name in home cooking, part of the Middleby group, best known for the cast-iron stove that stays warm all day.
SourceAGA Elise 36 Induction owner's guide
AGA Elise 36 and Mercury 36 induction models per their US owner's guides.
Before you book,
in this order.
Each step comes from AGA's own guidance for E2 on its stoves. Follow it to the end: the last card says whether this is a visit.
Switch the zone off and wait until the glass is cool.
Check for a pan that boiled dry and clear anything packed tightly around the stove.
Should E2 come back during everyday cooking, book a visit so the installation and airflow can be checked.
What not to do
E2 is not a cracked glass or a dead coil. It is a heat warning from the electronics, and it can be triggered by the installation or a dry pan rather than a failed part.
What you may
notice with it.
The stove problems E2 tends to arrive with. Answer these at the stove before anyone is booked.
All problems
Stove Error Code
8 causes, cheapest first
Where E2 usually leads
Glass stovetop repair.
AGA
stoves.
A British name in home cooking, part of the Middleby group, best known for the cast-iron stove that stays warm all day.
AGA stove repairMore AGA codes
All 15 AGA codesStovetop elements on other makes
Gas stove
A stove with gas burners on top, whether its oven below runs on gas too or on electricity, fed by one gas line behind it and plugged into a wall outlet for the spark.
Induction stove
A stove with a flat glass top that heats the pan itself through a magnetic field, run by touch keys and power boards, with an electric oven underneath.
Heritage stove
Classic stoves built the old way, from AGA cast-iron heat storage stoves to French and Italian enamel stoves with brass trim, kept for decades and repaired rather than replaced.
In AGA's own words
The electronic unit is too hot. Please check the installation of the range, making sure that there is sufficient ventilation.
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. AGA Elise 36 and Mercury 36 induction models per their US owner's guides.
AGA E2 stove repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about E2.
Can I clear E2 myself?
My AGA Elise showed E2 after a pot boiled dry. What now?
E2 keeps returning on my AGA Mercury induction top. Why?
Is it safe to use the other AGA induction zones while E2 is up?
Back to your everyday
Still showing E2?
Book with the code written exactly as the stove shows it, the full model number, and whether you notice any smell of gas or hot wiring — when there is a code, that is where the diagnosis starts.