BlueStar stove
showing F80
Temp Error F80 on a BlueStar stove points to a high temperature issue in the oven.
Mon–Sat, 8am–8pm
- Oven heating
- Stove oven heating repair
- Source: BlueStar
Book a visit
Three short steps, about a minute.
or call (844) 415-7620
Loading appointment form…
The appointment form couldn’t load. Please try again.
What F80
actually means.
Temp Error F80 on a BlueStar stove points to a high temperature issue in the oven. The oven got hotter than the control allows.
BlueStar stove display · also shown as Temp Error F80
What to do when F80 shows on the stoveKind of codeOven heating
The oven part of the stove was set to bake or broil and did not warm the way the controls expected, or took far too long to get there. On an electric stove a bake or broil element that has burned through is the everyday reason; on a gas stove the oven igniter and the valve it opens are looked at first. The wiring and the relay on the board are checked before the board itself is blamed.
Usually leads toStove oven heating repair
The oven part of a stove that stays cold, heats slowly or bakes too hot or too cool, fixed at the bake and broil elements, the oven igniter, the gas valve or the temperature sensor.
Shows up asOven on My Stove Runs Hot or Cold
Recipes take much longer or much less time than they should, cakes burn on the outside and stay raw inside, or an oven thermometer disagrees with the display by more than a little.
MakeBlueStar
A stove maker from Reading, Pennsylvania, whose gas burners are built to put out a lot of heat.
SourceBlueStar dual-fuel user manual 200009, Troubleshooting
BlueStar dual-fuel (BSDF) and Platinum induction (BSPIR) stoves with the oven touchscreen. No codes were confirmed for BlueStar's all-gas stoves.
Before you book,
in this order.
Each step comes from BlueStar's own guidance for F80 on its stoves. Follow it to the end: the last card says whether this is a visit.
Turn the oven off and keep the door closed while it cools; if you see smoke or flame, keep it closed and call 911.
Once cool, reset the breaker.
Do not keep baking if F80 returns; book a visit.
Still there?
It usually turns into stove oven heating repair. Book with the code and the model number.
What not to do
F80 is not an oven running a few degrees off. It flags heat well beyond normal.
What you may
notice with it.
The stove problems F80 tends to arrive with. Answer these at the stove before anyone is booked.
All problems
Oven on My Stove Runs Hot or Cold
7 causes, cheapest first
Where F80 usually leads
Stove oven heating repair.
BlueStar
stoves.
A stove maker from Reading, Pennsylvania, whose gas burners are built to put out a lot of heat.
BlueStar stove repair
Gas stove
A stove with gas burners on top, whether its oven below runs on gas too or on electricity, fed by one gas line behind it and plugged into a wall outlet for the spark.
Induction stove
A stove with a flat glass top that heats the pan itself through a magnetic field, run by touch keys and power boards, with an electric oven underneath.
In BlueStar's own words
Temp Error F80
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. BlueStar dual-fuel (BSDF) and Platinum induction (BSPIR) stoves with the oven touchscreen. No codes were confirmed for BlueStar's all-gas stoves.
BlueStar F80 stove repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about F80.
Can I clear F80 myself?
What makes a BlueStar oven show Temp Error F80?
Can I use the burners on my BlueStar stove after F80?
F80 showed during self-clean on my BlueStar stove. Is that different?
Back to your everyday
Still showing F80?
Book with the code written exactly as the stove shows it, the full model number, and whether you notice any smell of gas or hot wiring — when there is a code, that is where the diagnosis starts.