Electrolux stove shows F10
Electrolux's code guide lists F10 as thermal runaway on its earlier electric models.
Mon–Sat, 8am–8pm
- Oven heating
- Stove oven heating repair
- Source: Electrolux
Book a visit
Three short steps, about a minute.
or call (844) 415-7620
Loading appointment form…
The appointment form couldn’t load. Please try again.
What F10
actually means.
Electrolux's code guide lists F10 as thermal runaway on its earlier electric models. It means the oven got hotter than the control allows, and heating is cut as a protective step.
Electrolux stove display
What to do when F10 shows on the stoveKind of codeOven heating
The oven part of the stove was set to bake or broil and did not warm the way the controls expected, or took far too long to get there. On an electric stove a bake or broil element that has burned through is the everyday reason; on a gas stove the oven igniter and the valve it opens are looked at first. The wiring and the relay on the board are checked before the board itself is blamed.
Usually leads toStove oven heating repair
The oven part of a stove that stays cold, heats slowly or bakes too hot or too cool, fixed at the bake and broil elements, the oven igniter, the gas valve or the temperature sensor.
Shows up asOven on My Stove Runs Hot or Cold
Recipes take much longer or much less time than they should, cakes burn on the outside and stay raw inside, or an oven thermometer disagrees with the display by more than a little.
MakeElectrolux
A Swedish appliance group whose stoves in American kitchens often have their controls along the front edge.
SourceElectrolux: Ranges - Error Code Guide
F10 is listed here: Electrolux's owner support code guide, written for its earlier electric models (the articles say Electric Ranges); the current ECF gas, dual fuel and induction stoves show Err with a number instead.
Before you book,
in this order.
Each step comes from Electrolux's own guidance for F10 on its stoves. Follow it to the end: the last card says whether this is a visit.
Turn the oven knob to off and let the cavity cool without opening the door.
Pull out any foil lining the bottom of the oven or the racks.
Disconnect power for up to 30 seconds, then restore it and try a normal bake.
Book a visit if F10 repeats; the relays and sensor are tested.
Still there?
It usually turns into stove oven heating repair. Book with the code and the model number.
What not to do
F10 on an Electrolux does not mean the sensor is unplugged. The probe codes are F30 and F31; F10 means the temperature really rose too far.
What you may
notice with it.
The stove problems F10 tends to arrive with. Answer these at the stove before anyone is booked.
All problems
Oven on My Stove Runs Hot or Cold
7 causes, cheapest first
Where F10 usually leads
Stove oven heating repair.
Electrolux
stoves.
A Swedish appliance group whose stoves in American kitchens often have their controls along the front edge.
Electrolux stove repair
Gas stove
A stove with gas burners on top, whether its oven below runs on gas too or on electricity, fed by one gas line behind it and plugged into a wall outlet for the spark.
Induction stove
A stove with a flat glass top that heats the pan itself through a magnetic field, run by touch keys and power boards, with an electric oven underneath.
In Electrolux's own words
F10 - Thermal Runaway
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. F10 is listed here: Electrolux's owner support code guide, written for its earlier electric models (the articles say Electric Ranges); the current ECF gas, dual fuel and induction stoves show Err with a number instead.
Electrolux F10 stove repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about F10.
Can I clear F10 myself?
Can foil on the oven floor cause F10 on my Electrolux?
My Electrolux oven keeps heating with the knob off and shows F10. What now?
Does F10 appear on the newest Electrolux stoves?
Back to your everyday
Still showing F10?
Book with the code written exactly as the stove shows it, the full model number, and whether you notice any smell of gas or hot wiring — when there is a code, that is where the diagnosis starts.