The open oven of a freestanding stove, the racks pulled out and the bake element along the floor of the oven dark and cold under the oven light.

Frigidaire stove shows F10 while baking

Frigidaire calls F10 thermal runaway: the oven senses higher-than-normal temperatures and shuts down as a safety step.

(844) 415-7620

Mon–Sat, 8am–8pm

  • Oven heating
  • Stove oven heating repair
  • Source: Frigidaire

Book a visit

Three short steps, about a minute.

or call (844) 415-7620

Before you book,
in this order.

Each step comes from Frigidaire's own guidance for F10 on its stoves. Follow it to the end: the last card says whether this is a visit.

01

Shut the oven off and let it cool down with its door kept closed.

02

On a Stone-Baked Pizza model, move the rack and shield to rack position 7 or the position your guide gives.

03

Unplug or switch off the breaker for 30 seconds, then try again.

04

If F10 returns during a normal bake, stop using the oven and book a visit.

Still there?

It usually turns into stove oven heating repair. Book with the code and the model number.

What not to do

F10 is not a sensor wiring code. Frigidaire's probe codes are F30 and F31; F10 means the heat reading was real and too high.

What you may
notice with it.

The stove problems F10 tends to arrive with. Answer these at the stove before anyone is booked.

All problems

Where F10 usually leads

Stove oven heating repair.

Oven element, igniter, gas valve or sensor · low to moderate.

In Frigidaire's own words

F10 - Thermal Runaway
Frigidaire: Ranges - Error Code Guide Frigidaire: Oven Error Codes and Alarms Guide Frigidaire: Oven Error Codes and Alarms Guide

Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Frigidaire's range code guide and its oven error codes guide; the pizza shield note applies to Stone-Baked Pizza models.

Frigidaire F10 stove repair,
where we come out.

The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.

All service areas
A grandparent and a child stirring a pot together on a white gas stove in a lived-in family kitchen
For the heart of your home.

Questions
about F10.

Can I clear F10 myself?
Shut the oven off and let it cool down with its door kept closed. If it comes back, it needs a visit.
My Frigidaire shows F10 only when I make pizza. Why?
On Stone-Baked Pizza models, Frigidaire says a pizza shield on the wrong rack can cause it. Move it to rack position 7 and start the preheat again.
Is F10 on a Frigidaire a fire risk?
It is the oven protecting itself from overheating. Let it cool, and if you see smoke from the wiring or the oven keeps heating with the knob off, switch the breaker off.
Can I keep using my Frigidaire oven after an F10?
If it happened once and the oven bakes normally after cooling and a reset, yes. If F10 repeats, the controls need checking.

Back to your everyday

Still showing F10?

Book with the code written exactly as the stove shows it, the full model number, and whether you notice any smell of gas or hot wiring — when there is a code, that is where the diagnosis starts.

(844) 415-7620 Schedule a repair